Cisco TelePresence SX80 Reference Manual page 118

Cisco TelePresence SX80
Contents Introduction
xCommand Peripherals Pairing DeviceDiscovery Start
Start device discovery to detect ISDN Links in the same network.
AutoPairing: You can select to automatically pair the detected device to the endpoint.
DeviceType: Only look for ISDN Link.
Timeout: Set a maximum time for the search from 3 to 60 seconds.
Requires user role: ADMIN
Parameters:
AutoPairing: <On, Off>
DeviceType: <ISDNLink>
Timeout: <3..60>
Example:
xCommand Peripherals Pairing DeviceDiscovery Start
xCommand Peripherals Pairing Pair
Pair an ISDN Link to an endpoint.
MacAddress: Enter the MAC address for the ISDN Link you wish to pair to the endpoint.
Requires user role: ADMIN
Parameters:
MacAddress(r): <S: 1, 1450>
Example:
xCommand Peripherals Pairing Pair MacAddress: 1.2.3.4
xCommand Peripherals Pairing Unpair
Unpair endpoint from an ISDN Link, when the two have contact.
MacAddress: Enter the MAC address for the ISDN Link you wish to unpair from the endpoint.
Requires user role: ADMIN
Parameters:
MacAddress(r): <S: 1, 100>
Example:
xCommand Peripherals Pairing Unpair MacAddress: 1.2.3.4
Codec SX80 API Reference Guide TC7.3, OCTOBER 2015.
D15107.05
About the API xConfiguration
xCommand Peripherals Pairing Purge
118
xCommand xCommand
Force unpair an endpoint from an ISDN Link when a connection has been lost. Note: You must also
unpair the ISDN Link to be able to pair it to another endpoint.
Requires user role: ADMIN
Parameters:
ID(r): <S: 1, 100>
Example:
xCommand Peripherals Purge ID: 1.2.3.4
API Reference Guide
xStatus Appendices
Copyright © 2015 Cisco Systems, Inc. All rights reserved.