Mounting The Svi Ii Esd With Namur Kits; Namur 20/30 Mm Mounting Kit - GE Masoneilan SVI II ESD Installation And Maintenance Manual

Mounting the SVI II ESD with NAMUR Kits

There are two versions of this kit:
20 and 30 mm
50 mm
20 and 30 mm Mounting
Tools required:
3 mm hex key
4 mm hex key
Refer to Figure 43 for this procedure.
To mount using this kit:
1. Attach the mounting bracket to the valve actuator using four (4) M5 x 0.8 x 10 flat-head
cap screws.
Quarter Turn
Mounting Plate
2. Place the indicator disk with metal insert over the valve actuator shaft and secure using
an M6 x 1.0 x 45 socket-head screw.
3. Place the Quarter Turn Mounting Plate into place sliding it through the anti-backlash
spring into the dowel pin at the end of the plate into the hex head screw installed in step 2.
4. Secure the plate to the bracket using four (4) flat head cap screws.
64 |
=GE Oil & Gas
Mounting Bracket
Figure 43 Namur 20/30 mm Mounting Kit
Indicator Disc Bracket
© 2016 General Electric Company. All rights reserved.