Atm Commands - Cisco 10000 Series Configuration Manual

ATM Commands

To enable ILMI:
Create PVC 0/16 on the main interface as shown in the following example:
Step 1
Router(config)# interface atm 5/0/0
Router(config-if)# pvc 0/16 ilmi
Router(config-if-atm-vc)# exit
Router(config-if)#
In the following example, ILMI PVC discovery is enabled for the selected port on the 4-Port
Step 2
OC-3/STM-1 ATM line card (step 1 references port 0).
Router(config-if)# atm ilmi-pvc-discovery
You have completed the steps required for running ILMI PVC discovery. You can use the show atm pvc
command to display the PVCs on the Cisco 10000 series router.
Completing a Configuration
This section offers general information on creating and completing a configuration of an 4-Port
OC-3/STM-1 ATM line card.
To configure and interface:
Enter interface configuration mode and then specify necessary parameters, such as the IP address and
Step 1
subnet mask.
After you enter all of the configuration subcommands to complete the configuration, enter Ctrl-Z (hold
Step 2
down the Control key while you press Z) to exit configuration mode.
Write the new configuration to memory:
Step 3
Router# copy running-config startup-config
The system displays an OK message when the configuration is stored. After you have completed your
configuration, you can check it by using show commands.
ATM Commands
Each 4-Port OC-3/STM-1 ATM line card permits you to specify up to four OC-3 interfaces. You can put
all the PVCs on the main interfaces, or you can create associated subinterfaces. This section describes
the principal commands for customizing interfaces and PVCs:
•
•
•
•
Cisco 10000 Series Router Line Card Configuaration Guide
1-6
Global Configuration Command, page 1-7
Interface and Subinterface Commands, page 1-7
ATM PVC Commands, page 1-15
Useful show Commands, page 1-19
Chapter 1 4-Port OC-3/STM-1 ATM Line Card Configuration
OL-8834-04