Cisco 10000 Series Configuration Manual page 350

Chapter 18 Configuration Examples
Example 4: MPLS Virtual Private Networks
Configuring Static Route PE to CE Routing Sessions
To configure static route PE to CE routing sessions, use the following commands in router configuration
mode on the PE router:
Define static route parameters for each PE to CE session and for each BGP PE to CE routing session.
Router(config)# ip route vrf go_fast_internet_company 200.28.28.46 255.255.255.0
200.28.28.50
Router(config-router)# address-family ipv4 unicast vrf go_fast_internet_company
Redistribute VRF static routes and directly connected networks into the VRF BGP table.
Router(config-router-af)# redistribute static
Router(config-router-af)# redistribute static connected
Cisco 10000 Series Router Line Card Configuaration Guide
18-10
OL-8834-04