C H A P T E R 14 1-Port Oc-48/Stm-16 Packet Over Sonet Line Card Configuration - Cisco 10000 Series Configuration Manual

Default Values
Checking Hardware and Software Compatibility
The PRE installed in the Cisco 10000 series router chassis must support the Cisco IOS software running
on the router. Use the show version command to check the PRE version installed.
To see if a feature is supported by a Cisco IOS release, to locate the software document for that feature,
or to check the minimum software requirements of Cisco IOS software with the hardware installed on
your router, Cisco maintains the Software Advisor tool on Cisco.com at
http://www.cisco.com/cgi-bin/Support/CompNav/Index.pl
This tool does not verify whether line cards within a system are compatible, but does provide the
minimum Cisco IOS requirements for individual hardware line cards, modules, or options.
You must be a registered user on Cisco.com to access this tool.
Default Values
Table 14-2
also includes the command used for modifying a default value and indicates whether a value needs to be
the same (or opposite) on the remote end of the connection.
Table 14-2
Command Name
bandwidth
clock source
crc
encapsulation
keepalive
mtu (maximum
transmission unit)
MAC Protocol
pos framing
pos scramble-atm
pos flag (SONET
overhead)
SDCC Default Values
Table 14-3
configure a SONET Section Data Communications Channel (SDCC) interface.
The table includes the command used for modifying a default value and indicates whether a value needs
to be the same (or opposite) on the remote end of the connection.
Cisco 10000 Series Router Line Card Configuaration Guide
14-2
lists default values for the 1-Port OC-48/STM-16 Packet over SONET line card. This table
1-Port OC-48/STM-16 Packet over SONET Line Card SONET Defaults
Default
Setting
2488
line
32
HDLC
10
4470
pos
SONET
No scrambling
c2 to 0xcf
j0 to 0x01
s1s0 to 0
lists default values for the 1-Port OC-48/STM-16 Packet over SONET line card if you
Chapter 14 1-Port OC-48/STM-16 Packet over SONET Line Card Configuration
Command Syntax
bandwidth kilobits
clock source [line | internal]
crc [16 | 32]
encapsulation [hdlc | ppp | frame-relay]
[no] keepalive period
mtu size
hw-module slot [pos]
pos framing [sonet | sdh]
[no] pos scramble-atm
pos flag [c2 | j0 | s1s0] value
Remote Side
Setting
Same
At least one side
must be set to
internal.
Same
Same
Same
Same
Same
Same
Same
Same
OL-8834-04