Cisco 10000 Series Configuration Manual page 189

Chapter 7 4-Port Channelized OC-3/STM-1 Line Card Configuration
Table 7-7
when the 4-Port Channelized OC-3/STM-1 line card is configured for SONET framing.
Table 7-4
Command Name
SONET Controller Configuration Mode
clock source
framing
loopback
overhead
1. The default value for SONET clock source is line. At least one side of the connection must be set to internal.
Table 7-5
Command Name
T3 Controller Configuration Mode
cablelength
channelized
clock source
framing
idle pattern
overhead
Table 7-6
Command Name
VT Controller Configuration Mode
overhead
OL-8834-04
lists the default values for commands that are available in VT controller configuration mode
Default Values for SONET Controller Configuration Commands under SONET
Framing
Default
Setting Command Syntax
1
line
clock source {internal | line}
sdh
framing {sonet | sdh}
no loopback
[no] loopback {internal | line}
1 for J0
overhead {j0 | s1s0}
0 for S1S0
Default Values for T3 Controller Configuration Commands under SONET Framing
Default
Setting Command Syntax
0
cablelength length
channelized
[no] channelized
internal
clock source {line | internal}
auto-detect
framing {auto-detect | c-bit | m23}
0X7e (flags)
idle pattern {0x0 to 0xFF}
4 for c2
overhead {c2 | j1}
64 for j1
Default Values for VT Controller Configuration Commands under SONET Framing
Default
Setting Command Syntax
2 for c2
overhead {c2 | j1}
64 for j1
Cisco 10000 Series Router Line Card Configuaration Guide
Default Values
Remote Side Setting
One side set to internal
Same
—
—
Remote Side Setting
—
—
One side set to internal
Same
Same
—
Remote Side
Setting
—
7-5