E1 Interface Numbering Syntax - Cisco 10000 Series Configuration Manual

Chapter 5 24-Port Channelized E1/T1 Line Card Configuration
Table 5-2
Command Name
Controller Configuration Commands
bert
channel-group
clock source
description
framing
linecode
loopback
national reserve
shutdown

E1 Interface Numbering Syntax

You can use the line card in different Cisco series 10000 router chassis. To specify line card E1
interfaces, use the syntax listed in
Table 5-3
Router
Cisco 10008
Cisco 10005
Because this is a full-height line card, its subslot value is always 0.
Note
Examples:
•
OL-8834-04
E1 Line Card Commands and Default Values (continued)
Default Value
No bert
No channel-group
line
No description
crc4
hdb3
No loopback
No national
reserve (0)
no shutdown
E1 Line Card Interface Syntax
Con troller
E1
E1
Modify E1 controller 0 in slot 2 in controller configuration mode:
Router(config)# controller e1 2/0/0
Router(config-controller)# command
Router(config-controller)#
Command Syntax
[no] bert pattern {2^11 | 2^15 | 2^20-0153 |
2^20-QRSS} interval minutes
[no] channel-group channel number {timeslots
timeslots [speed 64] | unframed}
[no] clock source {internal | line}
[no] description text
[no] framing {crc4 [australia]| no-crc4
[australia]}
[no] linecode hdb3
[no] loopback {local | network {line |
payload}}
[no] national reserve int sa4 sa5 sa6 sa7
sa8
[no] shutdown
Table 5-3 for the router chassis in use.
Slot Subslot Port Number
1 to 8 /0 /0 to /23
1 to 5 /0 /0 to /23
Cisco 10000 Series Router Line Card Configuaration Guide
Commands and Default Values
Remote
Device
Setting
—
—
At least
one side
set to
internal
—
—
—
—
—
—
Channel Group Number
:1 to:31
:1 to:31
5-3