Interface Syntax - Cisco 10000 Series Configuration Manual

Chapter 12 6-Port OC-3/STM-1 Packet over SONET Line Card Configuration

Interface Syntax

To specify an interface number in a configuration command, use the syntax in
interfaces on the 6-Port OC-3/STM-1 Packet over SONET line card.
Table 12-3
Type of Interface
Packet over SONET interface
The following example shows the syntax for configuring a 6-Port OC-3/STM-1 Packet over SONET line
card in slot 1:
Router(config)# interface pos 1/0/0
Configuring the Interface
After you verify that the 6-Port OC-3/STM-1 Packet over SONET line card is installed correctly, use the
following procedure to configure the new interface. Be prepared with the information you will need,
such as the interface IP address.
Use the following procedure to create a basic configuration—enable an interface and specify IP routing.
At the global configuration prompt, specify the new interface to configure by entering the interface pos
Step 1
command and interface address. For example:
Router(config)# interface pos 1/0/1
Assign an IP address and a subnet mask to the interface using the ip address configuration subcommand,
Step 2
as in the following example:
Router(config-if)# ip address 192.168.255.255 255.255.255.0
Specify either HDLC or PPP encapsulation. For example:
Step 3
Router(config-if)# encapsulation hdlc
If necessary, modify the 6-Port OC-3/STM-1 Packet over SONET line card configuration or that of the
Step 4
remote device to ensure that, where appropriate, they use the same settings. For more information, refer
to the Remote Side Setting column in
Add any other configuration subcommands required for the enabling of routing protocols and adjust the
Step 5
interface characteristics.
Step 6 Enter the no shutdown command to enable the interface.
Router(config-if)# no shutdown
When you have included all of the configuration subcommands to complete the configuration, enter
Step 7
Crtl-Z to exit configuration mode.
Step 8 Write the new configuration to memory.
Router# copy running-config startup-config
OL-8834-04
6-Port OC-3/STM-1 Packet over SONET Line Card Interface Syntax
Slot
1 to 8
Table
Subslot Port
0 0 to 5
12-2.
Cisco 10000 Series Router Line Card Configuaration Guide
Interface Syntax
Table 12-3 to identify
12-3