Line Card Interface Syntax - Cisco 10000 Series Configuration Manual

Line Card Interface Syntax

Line Card Interface Syntax
To specify an unchannelized or 1-Port Channelized OC-12/STM-4 line card interface in a configuration
command, use the syntax shown in
Table 6-12 Interface Syntax for the 1-Port Channelized OC-12/STM-4 Line Card
Type of
Interface
Unchannelized 1 to 8/ 0/
Channelized
Examples:
•
•
SONET-Framed Interface Configuration Sample
You can configure up to 12 STS-1 connections on a 1-Port Channelized OC-12/STM-4 line card. Each
STS-1 connection can be configured as a T3 controller or as a VT controller.
The following procedure walks you through the basic steps for creating full-rate and subrate T3
interfaces, as well as T1 and fractional T1 interfaces. Each T3 controller can be configured as a single
T3 interface (full or subrate), as 28 T1 interfaces, or as an even larger number of fractional T1s.
Set the framing type to SONET using the framing command.
Step 1
Router(config)# controller sonet 2/0/0
Router(config-controller)# framing sonet
Step 2 Assign an STS-1 path to a T3 interface. In this example, the path command is used to set up four T3
interfaces:
Router(config-controller)# path 1 controller t3
Router(config-controller)# path 2 controller t3
Router(config-controller)# path 3 controller t3
Router(config-controller)# path 4 controller t3
Router(config-controller)# exit
Step 3 Create an interface. In the following examples, each type of interface is created in a different T3
controller (4/0/0.1 through 4/0/0.4).
Cisco 10000 Series Router Line Card Configuaration Guide
6-8
Sub-
Slot slot
1 to 8/ 0/
Modifying T1 interface 6 in controller configuration mode:
Router(config)# controller t3 2/0/0.1
Router(config-controller)# t1 6 command
Modifying T1 interface 6, channel group number 8 in interface configuration mode:
Router(config)# interface serial 2/0/0.1/6:8
Router(config-if)
Chapter 6 1-Port Channelized OC-12/STM-4 Line Card Configuration
Table 6-12.
STS-1 T1 or E1
Port Path (T3) Number
0. 1 to 12 —
0. 1 to 12/ 1 to 28: for T1
1 to 32: for E1
Channel
Group
Number
—
0 to 23 for T1
0 to 31 for E1
OL-8834-04