C H A P T E R 8 6-Port Channelized T3 Line Card Configuration - Cisco 10000 Series Configuration Manual

Chapter 8 6-Port Channelized T3 Line Card Configuration
Table 8-2
Command Name
framing
idle character
keepalive
mtu (maximum
transmission unit)
scramble
Interface Syntax
To specify an interface number in a configuration command, use the syntax in
interfaces on the 6-Port Channelized T3 line card.
Table 8-3
Type of Interface Slot
Unchannelized
Channelized
Examples:
•
•
Interface Configuration Sample
Each T3 controller can be configured as a single T3 interface (full or subrate), as 28 T1 interfaces, or as
an even larger number of fractional T1s. The following procedure walks you through the basic steps for
creating full-rate and subrate T3 interfaces, as well as T1 and fractional T1 interfaces:
Create an interface. In the following examples, each type of interface is created in a different T3
Step 1
controller (2/0/0 through 2/0/3).
OL-8834-04
6-Port Channelized T3 Line Card Default Values (continued)
Default
Setting
c-bit
flags (0x7e)
keepalive
(10 sec)
4470
No
scrambling
6-Port Channelized T3 Line Card Interface Syntax
Subslot
1 to 8/ 0/
1 to 8/ 0/
Modifying T1 interface 6 in controller configuration mode:
Router(config)# controller t3 2/0/0
Router(config-controller)# t1 6 command
Modifying T1 interface 6, channel group number 8 in interface configuration mode:
Router(config)# interface serial 2/0/0/6:8
Router(config-if)
Remote Side
Command Syntax Setting
Same
framing [c-bit |
m13]
Same
idle character
[flags | marks]
Same
keepalive
Same
mtu size
Same
[no] scramble
Port (T3
Number) T1 Number
0 to 5 —
0 to 5/ 1 to 28
Cisco 10000 Series Router Line Card Configuaration Guide
Interface Syntax
DS 0 T1 Ch T3
x
x
Table 8-3 to identify
Channel
Group
Number
—
0 to 23
Unch
T3
x
x
x
x
x
8-3