Command Reference - Cisco 10000 Series Configuration Manual

Chapter 4 4-Port Channelized T3 Half-Height Line Card Configuration

Command Reference

The following commands are new in Cisco IOS Release 12.2(28)SB:
•
•
•
show controllers t3 bert Command
To display BER test statistics, use the show controllers t3 bert command in EXEC or privileged EXEC
mode.
Syntax Description
slot
subslot
port
t1-number
bert
Command Modes
EXEC
Privileged EXEC
Command History Release
12.2(28)SB
Examples
The following example shows BER test statistics for an unchannelized T3 interface:
Router# show controllers t3 6/1/0 bert
T3 6/1/0 is up.
BERT test result (done)
Test Pattern : 2^15, Status : Not Sync, Sync Detected : 1
Interval : 5 minute(s), Time Remain : 0 minute(s)
Bit Errors (since BERT started): 0 bits,
Bits Received (since BERT started): 13025 Mbits
Bit Errors (since last sync): 0 bits
Bits Received (since last sync): 13025 Mbits
The following example shows BER test statistics for a channelized T3 interface:
Router# show controllers t3 6/1/0 bert
T3 6/1/0 is up.
BERT test result (running)
Test Pattern : 2^15, Status : Sync, Sync Detected : 1
Interval : 3 minute(s), Time Remain : 1 minute(s)
Bit Errors (since BERT started): 0 bits,
OL-8834-04
show controllers t3 bert
linecard-group y-cable
member subslot
show controllers t3 {slot/subslot/port} [/t1-number] bert
Chassis line card slot number.
Chassis line card subslot number.
Interface number on the line card.
(Optional) Logical T1 interface number.
Displays BER test statistics.
Modification
This command was introduced on the Cisco 10000 series routers.
Cisco 10000 Series Router Line Card Configuaration Guide
Command Reference
4-31