Software Support - Cisco 10000 Series Configuration Manual

6-Port OC-3/STM-1 Packet over SONET Line Card
Configuration
This chapter describes the procedures for configuring the Cisco 10000 series 6-Port OC-3/STM-1 Packet
over SONET line card, hereafter known as the 6-Port OC-3/STM-1 Packet over SONET line card.
The 6-Port OC-3/STM-1 Packet over SONET line card provides 6 STS-3/STM-1 Packet over SONET
trunk uplinks that support throughput of up to 155.52 Mbps each over a SONET/ITU-T Synchronous
Digital Hierarchy (SDH) interface. Each port (0 to 5) has a single-mode optical fiber intermediate-reach
LC connector.
This chapter contains the following sections:
•
•
•
•
•

Software Support

Table 12-1
OC-3/STM-1 Packet over SONET line card.
Table 12-1
Required PRE
PRE1
PRE2
OL-8834-04
Software Support, page 12-1
Default Values, page 12-2
Interface Syntax, page 12-3
Configuring the Interface, page 12-3
Configuration Commands, page 12-4
shows the minimum Cisco IOS release on each release train that supports the 6-Port
6-Port OC-3/STM-1 Packet over SONET Line Card Software Support
Minimum Cisco IOS Releases
Cisco IOS Release12.0(22)S and later releases of Cisco IOS Release12.0S
Cisco IOS Release 12.0(20)ST and later releases of Cisco IOS 12.0ST
Cisco IOS Release12.0(22)S and later releases of Cisco IOS Release12.0S
Cisco IOS Release 12.2(8)BZ and later releases of Cisco IOS Release 12.2BZ
Cisco IOS Release 12.3(7)XI and later releases of Cisco IOS 12.3XI
Cisco IOS Release 12.2(28)SB and later releases of Cisco IOS 12.2SB
C H A P T E R
Cisco 10000 Series Router Line Card Configuaration Guide
12
12-1