Configuring The Ip Address; Configuring Routing - Cisco 10000 Series Configuration Manual

Configuring the Interface

Configuring the IP Address

To set the IP address of the interface, enter the following command:
Router(config-if)# ip address ip-address mask
Specifying Full or Half Duplex Mode
If the negotiation of the duplex mode fails, and a duplex mode mismatch occurs, manually set the duplex
mode.
Note The 8-Port Fast Ethernet Half-Height line card only responds to 802.3x pause frames from another
device when it autonegotiates the duplex mode (the default). The line card does not support 802.3x flow
control when you manually set half-duplex or full-duplex mode.
Set the duplex mode using the following command:
Router(config-if)# [no] {half-duplex | full-duplex}
The no option disables the duplex setting. If no duplex mode is set, the mode reverts to autonegotiation.
Configuring 802.1Q VLAN Encapsulation
The 8-Port Fast Ethernet Half-Height line card supports 802.1Q VLAN encapsulation. The card does not
support Inter-Switch Link (ISL) encapsulation. To set 802.1Q encapsulation, enter:
Router(config-if)# [no] encapsulation dot1q vlan-id [native]
•
•
•

Configuring Routing

See the
RIP or OSPF.
Cisco 10000 Series Router Line Card Configuaration Guide
9-4
vlan-id—The VLAN identifier, between 1 and 1000.
native—Sets the Port VLAN ID (PVID) value of the port to the vlan-id value.
no—Disables encapsulation.
Cisco IOS Command References
Chapter 9 8-Port Fast Ethernet Half-Height Line Card Configuration
for information about configuring routing protocols, such as
OL-8834-04