Software Support - Cisco 10000 Series Configuration Manual

1-Port Gigabit Ethernet Half-Height Line Card
Configuration
This chapter describes procedures for configuring the Cisco 10000 series 1-Port Gigabit Ethernet
Half-Height line card, hereafter known as the 1-Port Gigabit Ethernet Half-Height line card.
The 1-Port Gigabit Ethernet Half-Height line card contains a single Gigabit Ethernet port that provides
a trunk uplink to switches and core routers.
This chapter contains the following sections:
•
•
•
•
•
For information about installing half-height line cards in subslot locations, see the
Note
Router Line Card Hardware Installation

Software Support

Table 10-1
Ethernet Half-Height line card.
Table 10-1
Required PRE
PRE1
PRE2
PRE3
OL-8834-04
Software Support, page 10-1
Default Values, page 10-2
Interface Syntax, page 10-2
Configuring an Interface, page 10-3
Configuration Commands, page 10-3
shows the minimum Cisco IOS release on each release train that supports the 1-Port Gigabit
1-Port Gigabit Ethernet Half-Height Line Card Software Support
Minimum Cisco IOS Releases
Cisco IOS Release 12.0(23)S and later releases of Cisco IOS 12.0S
Cisco IOS Release 12.2(15)BX and later releases of Cisco IOS 12.2BX
Cisco IOS Release12.3(7)XI and later releases of Cisco IOS 12.3 XI
Cisco IOS Release 12.2(28)SB and later releases of Cisco IOS 12.2SB
Cisco IOS Release 12.2(31)SB2 and later releases of Cisco IOS 12.2SB
C H A P T E R
Guide.
Cisco 10000 Series Router Line Card Configuaration Guide
10
Cisco 10000 Series
10-1