Configuration Examples - Cisco 10000 Series Configuration Manual

Chapter 15 8-Port Unchannelized E3/T3 Line Card Configuration

Configuration Examples

This section contains examples to configure both full-rate and subrate E3 or T3 interfaces on the line
card. You must be in privileged EXEC mode to designate, create, and configure an E3 or T3 controller
and interface.
To view available command parameters, type ? at the command line.
Tip
Configuring an E3 Interface
The following sample procedure describes how to create and configure an E3 interface on port 6 of the
line card in slot 4.
Enter global configuration mode and designate the port as a controller.
Step 1
Router# configure terminal
Router(config)# controller dsx3 4/0/6
Configure the port as a dsx3 e3 controller and save the configuration to NVRAM.
Step 2
Router(config-controller)# dsx3mode e3
Router(config-controller)# end
Router# write
Enter configuration interface mode and designate port 6 as the serial interface.
Step 3
Router# configure terminal
Router(config)# interface serial 4/0/6
Step 4 Configure the E3 interface DSU parameters for the port as a full-rate or subrate interface:
a.
b.
Save the configuration to NVRAM.
Step 5
Router(config-if)# end
Router# write
Configuring a T3 Interface
The following sample procedure describes how to create and configure a T3 interface on port 6 of the
line card in slot 4.
Step 1 Enter global configuration mode and designate the port as a controller.
Router# configure terminal
Router(config)# controller dsx3 4/0/6
OL-8834-04
Full-rate (default 34,368):
Router (config-if)# dsu mode cisco
Router (config-if)#
Subrate (any value below 34,368):
Router (config-if)# dsu mode cisco
Router (config-if)# dsu bandwidth 16000
Cisco 10000 Series Router Line Card Configuaration Guide
Configuration Task Overview
15-5