Cisco 10000 Series Configuration Manual page 341

Configuration Examples
This chapter provides Cisco IOS CLI configuration examples for the Cisco 10000 series router. Each
example uses the commands you enter at the IOS command line interface (CLI).
This chapter contains the following examples:
•
•
•
•
Example 1: Configuring an Unchannelized Subrate T3 Port, Point
to Multipoint Frame Relay, and OSPF
This example provides the sequence of commands necessary to accomplish the following:
•
•
•
•
•
OL-8834-04
Example 1: Configuring an Unchannelized Subrate T3 Port, Point to Multipoint Frame Relay, and
OSPF, page 18-1
Example 2: OSPF, BGP, Channelized Full Rate T1, page 18-3
Example 3: Quality of Service Policy Propagation Using Border Gateway Protocol, page 18-5
Example 4: MPLS Virtual Private Networks, page 18-8
Configure an Unchannelized T3 Controller, page 18-2
Configure Subrate T3, page 18-2
Configure Frame Relay Encapsulation, page 18-2
Configure Point to Multipoint Frame Relay, page 18-2
Create an OSPF Routing Process, page 18-2
C H A P T E R
Cisco 10000 Series Router Line Card Configuaration Guide
18
18-1