Software Support - Cisco 10000 Series Configuration Manual

1-Port Gigabit Ethernet Line Card Configuration
This chapter describes procedures for configuring the Cisco 10000 series 1-Port Gigabit Ethernet line
card, hereafter known as the 1-Port Gigabit Ethernet line card.
The 1-Port Gigabit Ethernet line card provides:
•
•
This chapter contains the following sections:
•
•
•
•
•

Software Support

Table 11-1
Ethernet line card.
Table 11-1
Required PRE
PRE1
PRE2
PRE3
OL-8834-04
A trunk uplink to the core for Gigabit Ethernet aggregation
The Cisco 10000 system with an IEEE 802.3z-compliant Ethernet interface running at 1 Gbps in
full-duplex mode
Software Support, page 11-1
Default Values, page 11-2
Interface Syntax, page 11-2
Configuring an Interface, page 11-3
Configuration Commands, page 11-3
shows the minimum Cisco IOS release on each release train that supports the 1-Port Gigabit
1-Port Gigabit Ethernet Line Card Software Support
Minimum Cisco IOS Releases
Cisco IOS Release 12.0(22)S and later releases of Cisco IOS 12.0S
Cisco IOS Release 12.0(22)S and later releases of Cisco IOS 12.0S
Cisco IOS Release 12.3(7)XI and later releases of Cisco IOS Release 12.3XI
Cisco IOS Release 12.2(28)SB and later releases of Cisco IOS 12.2SB
Cisco IOS Release 12.2(31)SB2 and later releases of Cisco IOS 12.2SB
C H A P T E R
Cisco 10000 Series Router Line Card Configuaration Guide
11
11-1