C H A P T E R 15 8-Port Unchannelized E3/T3 Line Card Configuration - Cisco 10000 Series Configuration Manual

Default Values
Checking Hardware and Software Compatibility
The PRE installed in the Cisco 10000 series router chassis must support the Cisco IOS software running
on the router. Use the show version command to check the PRE version installed.
To see if a feature is supported by a Cisco IOS release, to locate the software document for that feature,
or to check the minimum software requirements of Cisco IOS software with the hardware installed on
your router, Cisco maintains the Software Advisor tool on Cisco.com at
http://www.cisco.com/cgi-bin/Support/CompNav/Index.pl
This tool does not verify whether line cards within a system are compatible, but does provide the
minimum Cisco IOS requirements for individual hardware line cards, modules, or options.
You must be a registered user on Cisco.com to access this tool.
Default Values
Table 15-2
also includes default values and indicates whether or not you must invoke a corresponding value at the
remote side Channel Service Unit/Data Service Unit (CSU/DSU).
Table 15-2
Command Name
Common Controller Configuration Mode
cable length
clock source
description
dsx3mode
shutdown
T3 Interface Configuration Mode
bert
description
dsu bandwidth
dsu mode
encapsulation
equipment
framing
idle character
Cisco 10000 Series Router Line Card Configuaration Guide
15-2
lists default configuration values for the 8-Port Unchannelized E3/T3 line card. This table
8-Port Unchannelized E3/T3 Line Card Parameters
Default Value
450
internal
—
t3
no shutdown
no bert
—
44,210
cisco
hdlc
customer
auto-detect
flags (0x7e)
Chapter 15 8-Port Unchannelized E3/T3 Line Card Configuration
Command Syntax
cablelength feet
clock source [line | internal]
description string
[no] dxs3mode [e3 | t3]
[no] shutdown
[no] bert pattern pattern interval time
[unframed]
description string
dsu bandwidth bandwidth
[no] bandwidth
dsu mode [adtran | cisco | digilink |
kentrox | larscom | verilink low-bit |
verilink high-bit]
encapsulation [hdlc | ppp |frame-relay]
equipment [customer | network]loopback
framing [auto-detect | c-bit | m13]
idle character [flags | marks]
Remote
CSU/DSU
Setting
—
At least
one side
set to
internal
—
Same
—
No
—
Same
Same
Same
Same
Same
Same
OL-8834-04