Configuring The Management Interface With A Second Ip Address - Cisco ASR 5500 Installation Manual

Initial System Configuration
Step 10
Optional – Configure the port speed by entering the following command:
medium { auto | speed { 10 | 100 | 1000 } duplex {full | half} }
Keyword/Variable Description
auto NOTE: Currently MIO/UMIO ports 1 and 2 only support a speed of 1000 Mbps. All other settings
are ignored.
Configures the system to auto detect the port speed.
speed NOTE: Currently MIO/UMIO ports 1 and 2 only support a speed of 1000 Mbps. All other settings
are ignored.
Specifies the port speed for the port itself. When manually configuring the port speed, you must ensure that
the network server configuration supports the speed and duplex configuration.
The possible rates are:



If you manually configure the port speed, you must also configure the duplex mode
duplex If you manually configure the speed, you must also use this parameter to configure the duplex mode. You
can implement either a full or half duplex mode.
NOTE: Ethernet networking rules dictate that if a device whose interface is configured to auto-
negotiate is communicating with a device that is manually configured to support full duplex mode,
the first device negotiates with the manually configured speed of the second device, but only
communicates in half duplex mode.
Step 11 Enter exit to exit the Ethernet Interface Configuration mode.
[local]host_name(config-port-<slot#/port#>)# exit
[local]host_name(config)#

Configuring the Management Interface with a Second IP Address

If necessary, you can configure a second IP address on the same MIO management interface.
Step 1
Enter configure to enter the configuration mode. The following prompt appears:
[local]host_name# config
[local]host_name(config)#
Step 2
Enter context local to enter the context configuration mode. The following prompt appears:
[local]host_name(config)# context local
[local]host_name(config-ctx)#
Step 3
Enter interface <interface_name> to specify the previously named interface.
[local]host_name(config-ctx)# interface local01
[local]host_name(config-if-eth)#
10 = 10 Mbps
100 = 100 Mbps
1000 = 1000 Mbps
Configure the Ethernet Management Interface ▀
ASR 5500 Installation Guide ▄
113