System Management
Table 87
synchronization
Syntax
synchronization
Context
show>redundancy
Platforms
7210 SAS-R6, 7210 SAS-R12, and 7210 SAS-Sx/S 1/10GE: standalone-VC
Description
This command displays redundancy synchronization times.
Output
The following output is an example of redundancy synchronization information, and
describes the output fields.
Sample Output
A:ALA-48>show>redundancy# synchronization
===============================================================================
Synchronization Information
===============================================================================
Standby Status
Last Standby Failure
Standby Up Time
Failover Time
Failover Reason
Boot/Config Sync Mode
Boot/Config Sync Status
Last Config File Sync Time
Last Boot Env Sync Time
===============================================================================
A:ALA-48>show>redundancy#
Table 88
654
Output Fields: Multi-Chassis Sync (Continued)
Label
Rem Alarm Entries
Output Fields: Synchronization
Label
Standby Status
Last Standby Failure
Standby Up Time
Failover Time
Use subject to Terms available at: www.nokia.com
7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Description
Displays alarm entries on the remote router
: disabled
: N/A
: N/A
: N/A
: N/A
: None
: No synchronization
: Never
: Never
Description
Displays the status of the standby CSM
Displays the timestamp of the last standby failure
Displays the length of time the standby CSM has been up
Displays the timestamp when the last redundancy failover
occurred causing a switchover from active to standby CSM
If there is no redundant CSM card in this system or no failover has
occurred since the system last booted, the value will be 0.
© 2021 Nokia.
Configuration Guide
Table 88
3HE 17358 AAAB TQZZA