Bof Chassis-Role And Host-Type Parameters For 7210 Sas-Sx 1/10Ge, 7210 Sas-S 1/10Ge, 7210 Sas-Sx 10/100Ge, And 7210 Sas-Mxp - Nokia 7210 Configuration Manual

7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
Figure 9
4.2.2 BOF Chassis-Role and Host-Type Parameters for
On the 7210 SAS-Sx 1/10GE, 7210 SAS-S 1/10GE, 7210 SAS-Sx 10/100GE and
7210 SAS-Mxp, the operator can configure the chassis-role and host-type boot
parameters to operate the 7210 SAS node in standalone mode or satellite mode. The
values configured for these parameters must be consistent for boot up to proceed
correctly.
host-type parameters are set to one of the allowed values.
The bof>host-type command can be set to one of the following values:
3HE 17358 AAAB TQZZA
System Initialization: TiMOS Boot
Three trials with
5 minute intervals
7210 SAS-Sx 1/10GE, 7210 SAS-S 1/10GE,
7210 SAS-Sx 10/100GE, and 7210 SAS-Mxp
Table 22 describes the boot loader action when the chassis-role and
• none (factory default setting)
• standalone
Use subject to Terms available at: www.nokia.com
T TiMOS boot up
Load TiMOS
Apply downloaded
configuration
Booting
for first time?
Or
Booting after reset to
factory default?
Yes
Ping safe-boot IP
address if
configured (in BOF)
Ping response received
for safe-boot IP address within
15 minutes?
Yes
Boot process
complete
Send trap to SNMP
© 2021 Nokia.
Boot process
No
complete
Send trap to SNMP
Reset to factory
No
default,
hard reboot
Boot Options
sw0476
141