Nokia 7210 Configuration Manual page 149

7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
TiMOS BOOT LOADER
CPLD Version: 2.1
Time from clock is FRI AUG 19 09:22:46 2016 UTC
USB:
scanning bus for devices...
1 USB Device(s) found
Number of blocks in device 0 is 0
Number of bytes per block in device 0 is 0
Switching serial output to sync mode...
Looking for cf1:/bof.cfg ... OK, reading
Contents of Boot Options File on cf1:
#eth-mgmt Port Settings:
#uplinkA Port Settings:
uplinkA-port
#uplinkB Port Settings:
uplinkB-port
#System Settings:
Hit a key within 3 seconds to change boot parameters...
Enter password to edit the Boot Options File
Or CTRL-D to exit the prompt
Password:
Incorrect password
Password:
Incorrect password
Password:
Incorrect password
3HE 17358 AAAB TQZZA
USB EHCI 1.00
primary-image ftp://*:*@xxx.xxx.xx.xx/xxx/xx/xxx/xx/xxx/both.tim
primary-config cf1:\sasm.cfg
no eth-mgmt-disabled
eth-mgmt-address xx.xxx.xx.xxx/24 active
eth-mgmt-route x.x.x.x/0 next-hop xx.xxx.xx.x
eth-mgmt-autoneg
eth-mgmt-duplex full
eth-mgmt-speed 100
1/1/1
uplinkA-autoneg
uplinkA-duplex full
uplinkA-speed 1000
uplinkA-address 0
uplinkA-vlan 0
1/1/2
uplinkB-autoneg
uplinkB-duplex full
uplinkB-speed 1000
uplinkB-address 0
uplinkB-vlan 0
wait 3
persist off
console-speed 115200
uplink-mode network
acl-mode IPv6-None
use-expansion-card-type
no console-disabled
Use subject to Terms available at: www.nokia.com
done
m4-ds1-ces
© 2021 Nokia.
Boot Options
149