Expanding A Vc By Adding A New Imm-Only Node; Removing A Node From A Vc (Standby Cpm Or Imm); Adding A New Standby Cpm Node Into An Existing Vc; Configuration Guidelines For Upgrading, Adding, Or Removing A Vc Node - Nokia 7210 Configuration Manual

Virtual Chassis

5.7.4 Expanding a VC by Adding a New IMM-only Node

This scenario is similar to
that instead of replacing an existing IMM-only node, a new node is being added. This
requires the configuration file on the active CPM to be updated by adding the new
IMM-only node VC configuration parameters using the config>system>vc-
stack>vc-stack-node command, without deleting or modifying any existing VC
configuration parameters.

5.7.5 Removing a Node from a VC (Standby CPM or IMM)

If the node to be removed is the standby CPM-IMM node, see
Active CPM-IMM Node with Another CPM-IMM Node
active CPM node by removing the VC configuration parameters for the node being
removed.
If the node to be removed is an IMM-only node, see
with Another Node
removing the VC configuration parameters for the node being removed.
5.7.6 Adding a New Standby CPM Node Into an Existing
This scenario is similar to
CPM-IMM
being added to the BOF of the active CPM node.
5.7.7 Configuration Guidelines for Upgrading, Adding, or
The following configuration guidelines apply for upgrading, adding, or removing a VC
node.
244
and update the configuration file on the active CPM node by
VC
Node, with the VC configuration information of the new CPM-IMM node
Removing a VC Node
• When upgrading an IMM-only node to a CPM-IMM node, ensure connectivity is
available between the IMM and the current active CPM-IMM node over the
stacking links.
Use subject to Terms available at: www.nokia.com
7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Replacing an IMM-only Node with Another Node
Replacing a Standby/Active CPM-IMM Node with Another
© 2021 Nokia.
Configuration Guide
Replacing a Standby/
and update the BOF on the
Replacing an IMM-only Node
3HE 17358 AAAB TQZZA
except