Nokia 7210 Configuration Manual page 527

7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
bidir-mip-egress
Syntax bidir-mip-egress [num-resources]
no bidir-mip-egress
Context configure>system>resource-profile>egress-internal-tcam>eth-cfm
Platforms 7210 SAS-R6 (IMMv2 and IMM-c) and 7210 SAS-R12 (IMMv2 and IMM-c)
Description This command allocates resources for the VPLS bi-directional MIP (both ingress and egress
directions) on SAPs only from the egress internal TCAM resource pool.
Note:
The no form of this command allocates no resources to this feature.
Default no bidir-mip-egress
Parameters num-resources — Specifies the number of resources to allocate.
mac-auth-res
Syntax mac-auth-res num-resources
no mac-auth-res
Context config>system>resource-profile>egress-internal-tcam
config>system>resource-profile>ingress-internal-tcam
Platforms 7210 SAS-Mxp (standalone), 7210 SAS-R6 (all IMMs), 7210 SAS-Sx/S 1/10GE
(standalone), 7210 SAS-T (network and access-uplink operating modes)
3HE 17358 AAAB TQZZA
• The resources in the egress internal TCAM resource pool are shared with other
features.
To assign resources to a specific feature, resources can be reallocated from other
features. For example, you can release resources by disabling the policies associated
with a SAP.
• Resources must be allocated from this pool before bi-directional MIPs can be
configured on VPLS SAPs.
• Bi-directional MIPs on VPLS SAPs can be enabled only when the bidir-mip-egress
resource slice is allocated and vpls-sap-bidir is enabled in the
configure>service>vpls>eth-cfm context.
Values 0 to 1
Use subject to Terms available at: www.nokia.com
© 2021 Nokia.
System Management
527