Nokia 7210 Configuration Manual page 425

7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
owner owner — Specifies the owner. The owner identifies the creator of this alarm. It
event
Syntax event rmon-event-id [event-type] [description description-string] [owner owner-string]
no event rmon-event-id
Context config>system>thresholds>rmon
Platforms Supported on all 7210 SAS platforms as described in this document, including platforms
configured in the access-uplink operating mode
Description This command configures an entry in the RMON-MIB event table. The event command
controls the generation and notification of threshold crossing events configured with the
alarm command. When a threshold crossing event is triggered, the rmon>event
configuration optionally specifies if an entry in the RMON-MIB log table should be created to
record the occurrence of the event. It may also specify that an SNMP notification (trap) should
be generated for the event. The RMON-MIB defines two notifications for threshold crossing
events: Rising Alarm and Falling Alarm.
Creating an event entry in the RMON-MIB log table does not create a corresponding entry in
the TiMOS event logs. However, when the event-type is set to trap, the generation of a Rising
Alarm or Falling Alarm notification creates an entry in the TiMOS event logs and that is
distributed to whatever TiMOS log destinations are configured: CONSOLE, session, memory,
file, syslog, or SNMP trap destination.
The TiMOS logger message includes a rising or falling threshold crossing event indicator, the
sample type (absolute or delta), the sampled value, the threshold value, the rmon-alarm-id,
the associated rmon-event-id and the sampled SNMP object identifier.
This no form of this command removes an rmon-event-id from the configuration.
Parameters rmon-event-type — Specifies the type of notification action to be taken when this event
3HE 17358 AAAB TQZZA
defaults to "TiMOS CLI". This parameter is defined primarily to allow entries that have
been created in the RMON-MIB alarmTable by remote SNMP managers to be saved
and reloaded in a CLI configuration file. The owner will not normally be configured by
CLI users and can be a maximum of 80 characters.
Default TiMOS CLI
occurs.
Values log — An entry is made in the RMON-MIB log table for each event
occurrence. This does not create a TiMOS logger entry. The RMON-
MIB log table entries can be viewed using the show system
thresholds command.
trap — A TiMOS logger event is generated. The TiMOS logger utility
then distributes the notification of this event to its configured log
destinations which may be CONSOLE, telnet session, memory log,
cflash file, syslog, or SNMP trap destinations logs.
Use subject to Terms available at: www.nokia.com
© 2021 Nokia.
System Management
425