Nokia 7210 Configuration Manual page 400

System Management
Description This command configures the Link Aggregation Control Protocol (LACP) system priority on
aggregated Ethernet interfaces. LACP allows the operator to aggregate multiple physical
interfaces to form one logical interface.
Default 32768
Parameters lacp-system-priority — Specifies the LACP system priority.
location
Syntax location location
no location
Context config>system
Platforms Supported on all 7210 SAS platforms as described in this document, including platforms
configured in the access-uplink operating mode
Description This command creates a text string that identifies the system location for the device.
Only one location can be configured. If multiple locations are configured, the last one entered
overwrites the previous entry.
The no form of this command reverts to the default value.
Parameters location — Specifies the location as a character string. The string may be up to 80
login-control
Syntax login-control
Context config>system
Platforms Supported on all 7210 SAS platforms as described in this document, including platforms
configured in the access-uplink operating mode
Description Commands in this context configure login control.
name
Syntax name system-name
no name
400
Values 1 to 65535
characters. Any printable, seven-bit ASCII characters can be used within the string.
If the string contains special characters (#, $, spaces, and so on), the entire string
must be enclosed within double quotes.
Use subject to Terms available at: www.nokia.com
7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
© 2021 Nokia.
Configuration Guide
3HE 17358 AAAB TQZZA