Boot Options
Existing uplinkA port settings are:
#uplinkA Port Settings:
uplinkA-port
#uplinkB Port Settings:
#uplinkB Port Settings:
uplinkB-port
Existing uplinkB port settings are:
New Settings
------------
#eth-mgmt Port Settings:
#uplinkA Port Settings:
uplinkA-port
160
Or "edit" to change the port settings:
uplinkA Port Setting
--------------------
1/1/1
uplinkA-autoneg
uplinkA-duplex
full
uplinkA-speed
1000
uplinkA-address
0
uplinkA-vlan
0
1/1/2
uplinkB-autoneg
uplinkB-duplex
full
uplinkB-speed
1000
uplinkB-address
0
uplinkB-vlan
0
uplinkA port is configured for Boot Interface Management,
Press ENTER to proceed with existing port settings
Or "disable" to disable the port for Boot Interface Management
Or "edit" to change the port settings:
uplinkB Port Setting
--------------------
uplinkB-port
1/1/2
uplinkB-address
0
uplinkB-vlan
0
uplinkB port is configured for Boot Interface Management,
Press ENTER to proceed with existing port settings
Or "disable" to disable the port for Boot Interface Management
Or "edit" to change the port settings:
primary-image
ftp://*:*@xxx.xxx.xxx.xx//home/****/images/both.tim
secondary-config
tftp://xx.xxx.xx.xxx/STU/config.cfg
no
eth-mgmt-disabled
eth-mgmt-address
xx.xxx.xx.xx/24
eth-mgmt-route
xx.xxx.x.x/16 next-hop xx.xxx.xx.x
eth-mgmt-route
xxx.xxx.x.x/16 next-hop xx.xxx.xx.x
eth-mgmt-autoneg
eth-mgmt-duplex
full
eth-mgmt-speed
100
1/1/1
uplinkA-autoneg
uplinkA-duplex
full
uplinkA-speed
1000
uplinkA-address
0
uplinkA-vlan
0
Use subject to Terms available at: www.nokia.com
7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
© 2021 Nokia.
Configuration Guide
3HE 17358 AAAB TQZZA