Sony SIR-1000W Instruction Manual page 82

8-2 Recording and Playback AUX Analog Data
Connecting the AUX Analog Signals (general purpose)
Recording AUX Analog Data Signal
Playing Back AUX Analog Data Signal
8-4
Analog signal source
Monitor equipment
1
Set the digital switch IRIG ON/OFF on the rear panel to the OFF (lower position).
2
Use a BNC cable (sold separately) to connect the AUX-2 (IRIG-B) IN connector on
the rear panel and the AUX analog data signal from the AUX analog signal source.
If necessary, use a BNC cable (sold separately) to connect monitoring equipment to the
AUX-2 (IRIG-B) OUT connector on the rear panel.
When the AUX analog data signal is input, the AUX-2 LED lights. If the LED does
not light, check the cable connections.
!
CAUTION
• If the digital switch IRIG ON/OFF is set to ON, AGC is applied to the AUX analog input signal.
• The rated input level of AUX analog data signals is ±2 Vpk.
The maximum input level is approximately ±3Vpk.
When recording starts, the AUX analog data signal input to the AUX analog channel can
be recorded on the tape simultaneously along the main data signals.
When a tape recorded with an AUX analog data signal is played back, the AUX analog
data signal is output from the AUX-2 (IRIG-B) OUT connector on the rear panel.
EXT. CONT COM SYNC IRIG ON / OFF
APD OFF / ON
(UP / DOWN)
REMOTE AUX-2 (IRIG-B) AUX-1 (DIGITAL) TRIG/REC
IN OUT IN OUT IN
OPTION SLOT 2
LSB DIGITAL
OUTPUT
D4 D3 D2 D1 8
8 7 6 5 4 3 2 1
IRIG ON/OFF
VOLTAGE
8 7 6 5 4 3 2 1 AC FUSE
!
! SELECTOR
T4A
220V
% / dB RAL / HLD
MST / SLV 9.6 / 19.2
240V
TRG S/M
PTRG OFF/ON
STAND BY
DC IN
AC IN
XLR 32F DC BREAKER
CANNON
OPTION SLOT 1
ANALOG
OUTPUT
7 6 5 4 3 2 1