Table of Contents
Advertisement
@£ ; key
• Press this key to shift the blinking channel or numerical digit on the LCD screen one
position to the left. When the blinking position reaches the left edge, pressing this key
once more causes it to jump to the right edge.
• Use this key when shifting the monitor channel in the direction of the smaller
numbers, and when raising the tape speed.
@¢ : key
• Press this key to shift the blinking channel or numerical digit on the LCD screen one
position to the right. When the blinking position reaches the right edge, pressing this
key once more causes it to jump to the left edge.
• Use this key when shifting the monitor channel in the direction of the larger numbers,
and when lowering the tape speed.
@∞ 8 key
• Press this key to increase the blinking channel or numerical digit on the LCD screen
by one step.
• Use this key when selecting the channel mode.
• To select the recorder or channel expantion units to be monitored on the LCD screen,
press the 8 or 9 key.
Note
Press the ALL CH key to set all channels to the same value.
@§ 9 key
Press only this key to decrease the blinking channel or numerical digit on the LCD
screen by one step.
Use this key when selecting the channel mode.
Note
• When the 8 or 9 keys are both held down for at least 2 seconds, the setting values
are set to the values listed below.
Be sure to set the values in the STOP mode.
At this time, the DATA or ANN/P-SV key is set to ANN/P-SV.
1) CHANNEL mode
2) Tape speed
3) Input range
4) Input DC offset
5) Output level
6) Monitor channel
7) LSB digital channel : OFF
• Press the ALL CH Key to set all channels to the same value.
: Maximum usable value from among
2 ch, 4 ch, 8 ch, and 16 ch
: 1 (normal speed)
: ±1 Vpk
: 0%
: ±1 Vpk
: CH 1
3-13
Advertisement
Chapters
Table of Contents
