ERROR MESSAGES AND SIGNALS
Automatic Self-Diagnotic Function
This model has an automatic self-diagnostic function which stops operation when there an error. When the interruption occurs
in fax mode, the following messages are displayed.
Display
Alphanumeric characters are blinking in the copy quantity
display and an alarm indicator is lit or blinking.
The following message is displayed.
ERROR
Display Messages
Message display
(Audible signal)
SENT
XXPAGE(S)
(Continous tone: 3 seconds)
RECEIVED
XXPAGE(S)
(Continous tone: 3 seconds)
READING
RECEIVING
12 NOV FRI 08:30
STAND-BY
ENTER FAX #
ONHOOK DIAL MODE
* These message are output during receiving-no messages are output during automatic reception.
5-10
Direct sending is finished. ("XX" is the number of sheets transmitted.)
Manual reception is finished. ("XX" is the number of sheets received.)
#001
Original is being read into memory (when using memory sending).
100%
A fax is being manually received.
Idle state.
100%
You pressed the SPEAKER key.
Cause and Remedy
Determine the type of error by looking at the alarm
indicators, and correct the problem. If the automatic self-
diagnostic fucntion is in effect, contact your dealer for
assistance.
Meaning