Setting And Adding The Ecc800 Collector; Setting Neteco Parameters - Huawei FusionDC1000A Commissioning Manual

FusionDC1000A Prefabricated All-in-One Data
Center
Commissioning Guide (IT Scenario)
Table 4-9 Description of the page for adding a device
Area
(1)
Management
domain
navigation tree
(2) Device
selection area
(3)
Management
domain
(4) Device
(5) Parameter
setting area
(6) Save

4.7.3 Setting and Adding the ECC800 Collector

The requirements for ECC800 WebUI login are as follows.
Computer operating system: Windows 7 or later supported
Browser: Chrome, Firefox, Internet Explorer 11 or later

4.7.3.1 Setting NetEco Parameters

Procedure
Step 1 Apply for a fixed IP address to the equipment room network administrator.
Step 2 Set the IP address, subnet mask, and default gateway on the ECC800-Pro WebUI.
Table 4-10 IP parameters
Path
System
Settings >
System
Parameter
s >
Monitor IP
> WAN_1
Issue 01 (2021-04-20)
Operation
In the management domain navigation tree, select the
management domain to which the device to be added
belongs.
Click the Device tab, select a device type from the drop-down
list box, and click the device to be added.
Drag the selected device to the management domain.
Click the device. The parameter setting area is displayed in the
right pane.
Set device parameters in the parameter setting area.
Click Save. The device is added.
Parameter Default
Value
IP 192.168.8.1
0
Subnet 255.255.25
mask 5.0
Copyright © Huawei Technologies Co., Ltd.
4 Commissioning Core Devices
Setting
Set this parameter based on the IP
address assigned by the network
administrator.
Set this parameter based on the
subnet mask assigned by the network
administrator.
50