Commissioning Guide Usage - Huawei FusionDC1000A Commissioning Manual

FusionDC1000A Prefabricated All-in-One Data
Center
Commissioning Guide (IT Scenario)
●
●
●
●
●
●
●
●
●
●
●
Huawei assumes no liability for any loss caused by unauthorized changes to the
initial configuration parameters.
Issue 01 (2021-04-20)
2

Commissioning Guide Usage

Verify that the configurations of various systems in the FusionDC1000 are
consistent with the initial configuration tables.
This manual describes how to perform power-on commissioning. For details
about drawings and initial configuration parameters required during
operations, see the appendix.
Conduct power-on commissioning only after the hardware is installed for the
FusionDC1000 and the installation is verified.
Power-on commissioning for each specific system must be performed under
instructions by qualified engineers.
The initial configuration parameters are essential to the reliable running of all
systems. Improper modifications of parameters may cause abnormal running
status, or even damage to systems.
The initial parameters of the FusionDC1000 are configured before delivery. For
details about how to modify the parameters, see the documents delivered
with the components and the actual solution configuration.
Prior to power-on commissioning, remove all the protective materials installed
for transporting the FusionDC1000A, such as the protective pads for smart
cooling products and the securing tape for smoke and heat detectors.
Before power-on commissioning, ensure that the aisle temperature is within
the normal range.
Do not perform power-on commissioning during a thunderstorm.
Verify that the upstream power supply is continuous during power-on
commissioning.
Operations marked as optional in chapters, sections, or procedures can be
performed depending on the actual situation.
Copyright © Huawei Technologies Co., Ltd.
2 Commissioning Guide Usage
15