Huawei FusionDC1000A Commissioning Manual page 62

Prefabricated all-in-one data center

Hide thumbs Also See for FusionDC1000A:

Table of Contents

FusionDC1000A Prefabricated All-in-One Data

Center

Commissioning Guide (IT Scenario)

Step 3 On the screen of the fire alarm control panel, choose Operation > Auto Login to

Step 4 Choose Bus Setting > Detector/Module Setting, and check that the device types

of the gas release indicator, fire alarm horn/strobe, and input/output module

correspond to the gas release indicator, indoor fire alarm horn/strobe, and outdoor

fire alarm horn/strobe respectively. If not, select the correct device type from the

drop-down list box.

Step 5 Disconnect cables from the electromagnetic valve.

Figure 5-1 Disconnecting cables from the electromagnetic valve

Step 6 Switch on the active and standby power supplies to the fire alarm control panel.

Step 7 Check whether the fire alarm control panel displays any alarm. If an alarm is

displayed, clear the alarm before performing follow-up operations.

Step 8 Press Keyboard and enter the password (the initial password is 111111) to unlock

the keyboard. Then press Auto/Manual to set the fire alarm control panel to the

Auto mode.

Issue 01 (2021-04-20)

NO TE

● The encoding indicator is steady on. Press the number keys to enter the address code to

be encoded, and then press the Run/Stop key to encode the address code.

● After the encoding is successful, the address code is displayed on the screen, and the

buzzer sounds once.

● If the encoding fails, the screen blinks

case, check that the cable connection and terminal type are correct, and then perform

the encoding again.

● If an incorrect address is entered, press Delete to delete the address and enter the

address to be encoded again.

5 System Commissioning

, and the buzzer sounds three times. In this

Table of Contents

V100r021c00