Commissioning Sensors; Setting And Adding A Smoke Detector (Connected To An Ai/Di Port On The Ecc800-Pro) - Huawei FusionModule500 Smart User Manual

FusionModule500 Smart Mini Data Center
User Manual (Philippines, FusionModule500-
SU61A12S)
Procedure
Step 1 Add a UPS2000G-L.
1.
2.
3.
----End

5.3.7 Commissioning Sensors

5.3.7.1 Setting and Adding a Smoke Detector (Connected to an AI/DI Port on
the ECC800-Pro)
If a smoke detector is installed, perform the following steps to configure it.
Context
If the detector is prefabricated, only check its settings.
Issue 02 (2021-06-30)
Log in to the ECC800-Pro WebUI as an administrator.
Add a UPS2000G-L.
Table 5-6 Adding a UPS2000G-L
Path Parameter
Choose Device
System attribute
Settings >
Device Type
Device
Management
and click Add
Connect To
Device. The
parameters
for adding
Communicati
devices are
ons Port
displayed.
Device
Address
Click Test Connect to check whether the UPS2000G-L connects to the
ECC800-Pro properly.
– If the connection succeeds, click Confirm. The connected devices are
displayed in the Number of connected devices list.
– If the connection fails, check whether the device is properly connected to
the ECC800-Pro, whether the device and ECC800-Pro are running
properly, and whether the parameter settings are consistent with the
device parameters.
Copyright © Huawei Technologies Co., Ltd.
5 Power-On Commissioning
Setting
Select UPS from the drop-down list box.
Select UPS2000G-L from the drop-down
list box.
Select ECC800 from the drop-down list
box.
Select COM4 from the drop-down list box.
NOTE
The setting example indicates that the
UPS2000G is connected to the COM4 port on
the ECC800-Pro. If the UPS2000G is connected
to another port, enter the number of the
connected port.
In this example, Device Address is set to 1.
During actual configuration, set the device
address for the UPS2000G-L based on the
actual situation.
119