Commissioning A Temperature Sensor; Commissioning A Temperature Sensor (Connected To The Ai/Di Port On The Ecc800) - Huawei ECC800 User Manual

ECC800 Data Center Controller
User Manual
Check Method
----End

5.5.5 Commissioning a Temperature Sensor

5.5.5.1 Commissioning a Temperature Sensor (Connected to the AI/DI port
on the ECC800)
If a temperature sensor is installed, perform the following steps to configure it.
Context



Procedure
Step 1 Set temperature sensor parameters.
1.
2.
3.
4.
5.
6.
7.
Step 2 Check the monitoring functions of the temperature sensor.
Table 5-29 Commissioning the sensor
Check Method
View the operating information
about the temperature sensor on
the WebUI.
----End
Issue 07 (2020-03-16)
If the sensor is prefabricated, only check its settings.
The actual value prevails. Only the method of the parameter settings is described.
If multiple temperature sensors are connected, commission them one by one.
In this example, the temperature sensor is connected to the AI/DI_2 port on the ECC800.
Log in to the ECC800 WebUI as the administrator.
Choose System Settings > Signal Name Modify. The Batch Signal Configuration
page is displayed.
Set Device Type to ECC800, set Device Name to ECC800, and click OK.
On the query result tab page, set the new signal name of AI/DI_2 to Temperature and
click Submit.
Choose Monitoring > System > ECC800 > Running Parameters > AI/DI_2 Port
Settings.
Set Temperature sensor to Enable and click Submit.
Confirm that Temperature sensor type is automatically identified as NTC. Ensure that
Temperature power supply is Yes.
Copyright © Huawei Technologies Co., Ltd.
Normal Connection Status
the app or WebUI.
Normal Connection Status
You can view the current cabinet temperature.
5 Power-On Commissioning
122