Commissioning A Door Status Sensor (Connected To The Ai/Di Port On The Rack Environment Unit) - Huawei ECC800 User Manual

ECC800 Data Center Controller
User Manual
7.
8.
Step 2 Check the door status sensor functions.
Table 5-27 Commissioning the sensor
Check Method
Open the cabinet door.
----End
5.5.4.2 Commissioning a Door Status Sensor (Connected to the AI/DI port
on the rack environment unit)
If a door status sensor is installed, perform the following steps to configure it.
Context


Procedure
Step 1 Set parameters for a door status sensor.
1.
2.
3.
4.
5.
Step 2 Check the door status sensor functions.
Table 5-28 Commissioning the sensor
Check Method
Close and then open the door.
Issue 07 (2020-03-16)
Set Door1 sensor type to Door sensor, ensure that Door1 power supply is Yes, and
click Submit.
Perform the preceding operations to set parameters for ports AI/DI_2 to AI/DI_8.
To use the AI/DI sensor, enable the corresponding AI/DI port and name the sensor. After
that, the specific alarm can be reported.
If the sensor is prefabricated, only check its settings.
In this example, the door status sensor is connected to the AI/DI_1 port on the rack environment unit 1.
Log in to the ECC800 WebUI as an administrator.
Choose Monitoring > IT Cabinet > IT Cabinet 1 > Cabinet Collector1 > Running
Parameters > AI/DI_1 Port Settings, set Door sensor to Enable, and click Submit.
Choose System Settings > Signal Name Modify. The Batch Signal Configuration
page is displayed.
Set Device Type to Cabinet Collector, set Device Name to Cabinet Collector1, and
click OK.
On the query result tab page, set the new signal name of AI/DI_1 to Door and click
Submit.
Copyright © Huawei Technologies Co., Ltd.
Normal Connection Status
Door1 DI alarm is generated on the active alarm page
of the app or WebUI.
Normal Connection Status
If the door status sensor is enabled, a cabinet door
open alarm is displayed on the active alarm page of
5 Power-On Commissioning
121