ABB IRC5 Compact Product Manual page 179

Removal
Use this procedure to remove one of the system fans.
1
2
3
4
5
6
7
8
Refitting
Use this procedure to refit one of the system fans.
1
2
3
4
Product manual - IRC5 Compact
3HAC047138-001 Revision: G
Action
DANGER
Before commencing any work inside the
cabinet, please observe the safety informa-
tion in section DANGER - Make sure that the
main power has been switched off! on
page 33.
CAUTION
Hot surface on top of the bleeder. Risk of
burns. Be careful when removing the unit.
Remove four attachment screws on the fan
cover.
Push the fan cover to the left and remove it.
Remove brake resistor bleeder.
Disconnect the connectors to the fan.
Loosen the attachment screw on the fan re-
ceptacle.
Push the fan according to illustration, to re-
lease and remove it.
Action
DANGER
Before commencing any work inside the
cabinet, please observe the safety informa-
tion in section DANGER - Make sure that the
main power has been switched off! on
page 33.
Put the fan in place and push it upwards.
Fasten the attachment screw on the fan re-
ceptacle.
Connect the connectors to the fan.
© Copyright 2009-2017 ABB. All rights reserved.
4.16 Replacement of system fans
Info/illustration
See Replacement of brake resistor
bleeder on page 175.
xx1400001456
Info/illustration
Continues on next page
4 Repair
Continued
179