Removing The Tray B Unit; Preparation; Procedure - Canon Booklet Finisher-D1 Service Manual

4
Parts Replacing and Cleaning > Stacking Assembly > Removing the Tray B Unit > Procedure

Removing the Tray B Unit

■ Preparation

1) Remove the Stack Wall (Lower).(Refer to page 4-29)
2) Remove the Stack Wall (Upper).(Refer to page 4-27)
3) Remove the Neat Stack Unit (Upper).(Refer to page 4-57)
4) Remove the Rear Upper Cover (Right).(Refer to page 4-21)
5) Remove the Rear Upper Cover (Left).(Refer to page 4-21)
6) Remove the Rear Cover.(Refer to page 4-20)
7) Remove the Inner Cover (Upper).(Refer to page 4-22)
8) Remove the Tray A Unit.(Refer to page 4-32)
9) Remove the Neat Stack Unit (Lower).(Refer to page 4-59)

■ Procedure

CAUTION:
When replacing or installing/removing the Tray B, be sure to perform the following
adjustment.
• Adjusting the Positions of the Tray A and B (Refer to page 4-37)
4 Parts Replacing and Cleaning > Stacking Assembly > Removing the Tray B Unit > Procedure
1) Pull out the Grounding Wire [1] and the harness [2] from the hole [A].
• 3 Screws [3]
• 1 Toothed Washer [4]
• 1 Connector [5]
x2
[4]
[3]
2) Remove the Tray B Cover [1].
• 4 Screws [2]
x4
[A]
[3]
[2]
[5]
[1]
F-4-61
[2]
[1]
F-4-62
4-35
4-35