Removing The Static Eliminator (Stack Tray Unit); Removing The Static Eliminator (Saddle Delivery Unit) - Canon Staple Finisher-AA1 Service Manual

3. Perform rear stapling once from the finisher
controls.
CAUTION:
Rear stapling is performed to position the staple-free
binding unit. If you do not perform this procedure,
empty stapling or position error in staple-free stapling
may occur.
Removing the Static
Eliminator (Stack tray Unit)
■ Preparation
1. Remove the stack tray.
" Removing the Stack Tray" on page 96
2. Remove the grate-shaped lower guide.
" Removing the Grate-Shaped Lower Guide" on page
96
3. Remove the side cover (right) [1].
• 1 screw [2]
1x
■ Procedure
1. Remove the static eliminator.
• 1 screw [1]
[2]
■ Handling after parts replacement
1. Clear the parts counter.
(LV1) COPIER > COUNTER > DRBL-2 > DL-STC
Removing the Static
Eliminator (Saddle Delivery Unit)
[1]
■ Procedure
1. Open the front cover [1], and pull out the saddle unit
[2].
[1]
2. Remove the static eliminator [1].
• 1 screw [2] each
112
4. Parts Replacement and Cleaning
1x
[2]
[1]
[2]