5) Close the Front Cover of the Finisher.
6) Move the Latch Mount (Rear) on the direction of the arrow and insert it to the pin to fix it.
• 1 Screw (Use the Screw removed in the step 7) of "Before Installing Finisher" )
Latch Plate(Rear)
7) Check the height between Finisher and the Document Insertion Unit.
CAUTION:
Height difference should be within +/-2 mm. Execute "Height Adjustment" if the
difference is +/-2 mm or more.
Finisher
7
Installation > Installation Procedure > Connecting with the Document Insertion Unit
Screw
F-7-59
Insertion Unit
F-7-60
7
Installation > Installation Procedure > Connecting with the Document Insertion Unit
8) Install the Rear Small Cover.
• 1 Screw
9) Install the Shunt Cable.
• 2 Screws (RS tighting; M4x10)
x2
Shunt Cable
7-23
F-7-61
7-23