Canon Booklet Finisher-D1 Service Manual page 352

5) Remove the Rear Cover.
• 2 Screws (Loosen)
• 6 Screws
x6
6) Measure the height [A] from the floor (where caster is landing) to the upper surface of the
bootom plate using a scale, and cheeck that the height is within 86.3 +/-0.3 mm.
If the height is not within the range, execute step 7) anf lettter.
7
Installation > Making Adjustments > Height Adjustment > Height Adjustment
F-7-77
[A]
86.3 0.3mm
F-7-78
7 Installation > Making Adjustments > Height Adjustment > Height Adjustment
7) Loosen the caster's fixing nut with the spanner in the direction of [A].
Spanner
CAUTION:
When loosening the caster fixing nut at the front side of the Saddle Finisher, be sure to
insert the spaner into the opening just below the Saddle botom plate.
Spanner
Saddle Bottom Plate
7-30
Fixing Nut
[A]
F-7-79
Fixing Nut
F-7-80
7-30