Canon Booklet Finisher-D1 Service Manual page 199

5
Adjustment > Adjustment at Time of Parts Replacement > Adjusting the Height of Corrugation Roller for Stack Delivery > Procedure
3) Set DIP SW382 [1] on the Switch PCB as shown in the figure below.
[1]
SW382
SW381
SW383 SW384 SW385
(-) (+)
4) Press the Push Switch SW385 [1] to complete preparation for the adjustment.
SW382
SW381
SW383 SW384 SW385
(-) (+)
5 Adjustment > Adjustment at Time of Parts Replacement > Adjusting the Height of Corrugation Roller for Stack Delivery > Procedure
ENTER
F-5-45
ENTER
[1]
F-5-46
5) By pressing the Push Switch SW383 [1] or SW384 [2], mode can be selected.
Every time SW384 [2] is pressed, "A / B / C / D / E" is displayed, in that order.
Display "A" on LED [3] (select the operation check mode).
6) Every time SW385 [4] is pressed, position of the 2 Corrugation Rollers [5] are changed.
Press SW385 [4] seven times to move the 2 Corrugation Rollers [5] to "corrugation position".
SW382
SW381
SW383 SW384 SW385
(-) (+)
[1]
[3]
ENTER
[2] [4]
F-5-47
[5]
F-5-48
5-23
5-23