Electric Control Assembly; Removing The Finisher Controller Pcb; Preparation; Procedure - Canon Booklet Finisher-D1 Service Manual

4
Parts Replacing and Cleaning > Electric Control Assembly > Removing the Neat Stack Driver PCB > Procedure

Electric Control Assembly

Removing the Finisher Controller PCB

■ Preparation

1) Remove the Rear Cover.(Refer to page 4-20)

■ Procedure

CAUTION:
When replacing the Finisher Controller PCB, be sure to perform the following
adjustment.
• Adjustment after Replacing the Finisher Controller PCB (Refer to page 5-53)
1) Remove the Finisher Controller PCB [1].
• 33 Connectors [2]
• 2 Connectors [3] (when the Puncher Unit is installed)
• 6 Screws [4]
• 1 Spacer [5]
[3]
[4]
x33
[3]
x2
[4]
[3]
x6
[4]
4 Parts Replacing and Cleaning > Electric Control Assembly > Removing the Neat Stack Driver PCB > Procedure
[3]
[5]
[4]
[3]
[1]
[4]
[3]
[4]
[3] [5] [3]
F-4-33

Removing the Neat Stack Driver PCB

■ Preparation
1) Remove the Rear Upper Cover (Right).(Refer to page 4-21)
2) Remove the Rear Upper Cover (Left).(Refer to page 4-21)
3) Remove the Rear Cover.(Refer to page 4-20)
■ Procedure
1) Remove the Neat Stack Driver PCB [1].
• 6 Connectors [2]
• 2 Screws [3]
• 2 Spacers [4]
[1]
4-24
[2]
[4]
x6
[3]
x2
[2]
[4]
[2]
[3]
F-4-34
4-24