Canon Booklet Finisher-D1 Service Manual page 204

5
Adjustment > Adjustment at Time of Parts Replacement > Adjusting Alignment Plate Position > Procedure
3) Place A4 paper [1] on the intermediate process tray. (Be sure to push in the paper to the
rear side of the process tray)
4) Pressing switch SW383 [1] or SW384 [2] determines adjustment level.
By pressing SW383 once, the LED [3] indicates "-1" and the front alignment plate [4] shifts
to the front by approx. 0.2mm. In the same way, by pressing SW384 once, the LED [3]
indicates "+1" and the front alignment plate [4] shifts to the rear by approx. 0.2mm.
• Adjustment range: +10 to -10 (shifting amount per unit: 0.2mm)
[3]
SW382
SW381
SW383 SW384 SW385
(-) (+) ENTER
[1] [2]
5 Adjustment > Adjustment at Time of Parts Replacement > Adjusting Alignment Plate Position > Procedure
[1]
F-5-60
[4]
F-5-61
5) Pressing push switch SW385 [1] determines shifting amount of the front alignment plate.
SW382
SW381
SW383 SW384 SW385
(-) (+)
6) Check that there is no gap between the paper's edge and the alignment plate after the
adjustment. If there is a gap, go through the procedure again from step 4).
ENTER
[1]
F-5-62
[1]
[2]
F-5-63
5-28
5-28