Canon Booklet Finisher-D1 Service Manual page 8

Preparation -------------------------------------------------------------------------------- 4-108
Procedure ---------------------------------------------------------------------------------- 4-108
Removing the Alignment Roller Unit --------------------------------------- 4-112
Preparation -------------------------------------------------------------------------------- 4-112
Procedure ---------------------------------------------------------------------------------- 4-112
Removing the Alignment Roller --------------------------------------------- 4-113
Preparation -------------------------------------------------------------------------------- 4-113
Procedure ---------------------------------------------------------------------------------- 4-113
Removing the Saddle Alignment Motor ----------------------------------- 4-113
Preparation -------------------------------------------------------------------------------- 4-113
Procedure ---------------------------------------------------------------------------------- 4-113
5
Adjustment
Basic Adjustment --------------------------------------------------------------5-2
Outline -------------------------------------------------------------------------------- 5-2
Height Adjustment ----------------------------------------------------------------- 5-3
Checking the height ------------------------------------------------------------------------ 5-3
Height adjustment -------------------------------------------------------------------------- 5-3
Side Registration/Skew Adjustment ------------------------------------------- 5-6
Checking adjustment value -------------------------------------------------------------- 5-6
Side registration adjustment ------------------------------------------------------------- 5-7
Skew adjustment ---------------------------------------------------------------------------- 5-8
Adjusting Sensor Light Intensity -----------------------------------------------5-10
Preparations --------------------------------------------------------------------------------5-10
Procedure ------------------------------------------------------------------------------------ 5-11
Adjustment at Time of Parts Replacement --------------------------- 5-12
Outline -------------------------------------------------------------------------------5-12
Adjusting Sensor Light Intensity -----------------------------------------------5-14
Preparations --------------------------------------------------------------------------------5-14
Procedure ------------------------------------------------------------------------------------5-15
Adjusting Position of Tray A, B ------------------------------------------------5-16
Adjusting the Alignment Position of the Upper Neat Alignment Plate 5-17
Preparations --------------------------------------------------------------------------------5-17
Procedure ------------------------------------------------------------------------------------5-17
Adjusting the Alignment Position of the Lower Neat Alignment Plate 5-19
Preparations --------------------------------------------------------------------------------5-19
Procedure ------------------------------------------------------------------------------------5-19
Adjusting the Height of Corrugation Roller for Stack Delivery ---------5-22
Preparations --------------------------------------------------------------------------------5-22
Procedure ------------------------------------------------------------------------------------5-22
Right Angle Adjustment of Alignment Plate---------------------------------5-26
Adjusting Alignment Plate Position -------------------------------------------5-27
Preparations --------------------------------------------------------------------------------5-27
Procedure ------------------------------------------------------------------------------------5-27
Adjusting Position of Stapler ---------------------------------------------------5-29
Adjusting Staple Position (1-stapling at the rear) -------------------------5-30
Preparations --------------------------------------------------------------------------------5-30
Procedure ------------------------------------------------------------------------------------5-30
Adjusting Staple Position (1-stapling at the front) ------------------------5-33
Preparations --------------------------------------------------------------------------------5-33
Procedure ------------------------------------------------------------------------------------5-33
Adjusting Staple Position (2-stapling positions) ---------------------------5-36
Preparations --------------------------------------------------------------------------------5-36
Procedure ------------------------------------------------------------------------------------5-36
Adjusting Delivery of Staple Stack (lower delivery) ----------------------5-38
Preparations --------------------------------------------------------------------------------5-38
Procedure ------------------------------------------------------------------------------------5-38
Adjusting Delivery of Staple Stack (saddle delivery) ---------------------5-41
Preparations --------------------------------------------------------------------------------5-41
Procedure ------------------------------------------------------------------------------------5-41
Saddle Stitch/Fold Placement Adjustment----------------------------------5-44
Fold placement adjustment -------------------------------------------------------------5-44
Saddle stitch adjustment -----------------------------------------------------------------5-45
Adjusting Saddle Stitching Position ------------------------------------------5-48
Preparations --------------------------------------------------------------------------------5-48
Procedure ------------------------------------------------------------------------------------5-48
Adjusting Saddle Folding Position --------------------------------------------5-50
Preparations --------------------------------------------------------------------------------5-50
Procedure ------------------------------------------------------------------------------------5-50
Adjusting Position of Saddle Lead Edge Stopper-------------------------5-51
Adjustment After Replacing Finisher Controller PCB --------------------5-53
Bufferless Mode -------------------------------------------------------------------5-54
Preparations --------------------------------------------------------------------------------5-54
Procedure ------------------------------------------------------------------------------------5-54