Canon Booklet Finisher-D1 Service Manual page 7

Procedure ------------------------------------------------------------------------------------4-68
Removing the Process Tray (Rear) ------------------------------------------4-69
Preparation ----------------------------------------------------------------------------------4-69
Procedure ------------------------------------------------------------------------------------4-69
Removing the Feed Belt --------------------------------------------------------4-70
Preparation ----------------------------------------------------------------------------------4-70
Procedure ------------------------------------------------------------------------------------4-70
Removing the Stack Delivery Motor ------------------------------------------4-72
Preparation ----------------------------------------------------------------------------------4-72
Procedure ------------------------------------------------------------------------------------4-72
Removing the Process Tray Plate Unit --------------------------------------4-72
Preparation ----------------------------------------------------------------------------------4-72
Procedure ------------------------------------------------------------------------------------4-72
Removing the Front Alignment Motor ----------------------------------------4-73
Preparation ----------------------------------------------------------------------------------4-73
Procedure ------------------------------------------------------------------------------------4-73
Removing the Rear Alignment Motor ----------------------------------------4-75
Preparation ----------------------------------------------------------------------------------4-75
Procedure ------------------------------------------------------------------------------------4-75
Right Angle Adjustment of Alignment Plate---------------------------------4-77
Removing the Process Upper Guide Unit ----------------------------------4-78
Preparation ----------------------------------------------------------------------------------4-78
Procedure ------------------------------------------------------------------------------------4-78
Removing the Belt Controller Unit --------------------------------------------4-81
Preparation ----------------------------------------------------------------------------------4-81
Procedure ------------------------------------------------------------------------------------4-81
Removing the Belt Roller -------------------------------------------------------4-85
Preparation ----------------------------------------------------------------------------------4-85
Procedure ------------------------------------------------------------------------------------4-85
Saddle Stitcher Assembly ------------------------------------------------- 4-89
Removing the Saddle Inner Cover (Upper) --------------------------------4-89
Preparation ----------------------------------------------------------------------------------4-89
Procedure ------------------------------------------------------------------------------------4-89
Removing the Saddle Inner Cover (Lower) --------------------------------4-89
Preparation ----------------------------------------------------------------------------------4-89
Procedure ------------------------------------------------------------------------------------4-89
Removing the Saddle Inlet Roller Static Eliminator ----------------------4-90
Preparation ----------------------------------------------------------------------------------4-90
Procedure ------------------------------------------------------------------------------------4-90
Removing the Saddle Intermediate Static Eliminator --------------------4-91
Preparation ----------------------------------------------------------------------------------4-91
Procedure ------------------------------------------------------------------------------------4-91
Removing the Saddle Stapler --------------------------------------------------4-91
Preparation ----------------------------------------------------------------------------------4-91
Procedure ------------------------------------------------------------------------------------4-91
Removing the Feed Guide Lower Static Eliminator ----------------------4-92
Preparation ----------------------------------------------------------------------------------4-92
Procedure ------------------------------------------------------------------------------------4-92
Removing the Disengagement Roller ----------------------------------------4-93
Preparation ----------------------------------------------------------------------------------4-93
Procedure ------------------------------------------------------------------------------------4-93
Removing the Thrust Unit -------------------------------------------------------4-95
Preparation ----------------------------------------------------------------------------------4-95
Procedure ------------------------------------------------------------------------------------4-95
Removing the Push-on Plate --------------------------------------------------4-97
Preparation ----------------------------------------------------------------------------------4-97
Procedure ------------------------------------------------------------------------------------4-97
Removing the Positioning Plate Unit -----------------------------------------4-98
Preparation ----------------------------------------------------------------------------------4-98
Procedure ------------------------------------------------------------------------------------4-98
Pulling out the Saddle Unit (service position) ------------------------------4-99
Preparation ----------------------------------------------------------------------------------4-99
Procedure ------------------------------------------------------------------------------------4-99
Removing the Saddle Inlet Static Eliminator ----------------------------- 4-100
Preparation -------------------------------------------------------------------------------- 4-100
Procedure ---------------------------------------------------------------------------------- 4-100
Removing the Saddle Unit ---------------------------------------------------- 4-101
Preparation -------------------------------------------------------------------------------- 4-101
Procedure ---------------------------------------------------------------------------------- 4-101
Removing the Press Unit ----------------------------------------------------- 4-102
Preparation -------------------------------------------------------------------------------- 4-102
Procedure ---------------------------------------------------------------------------------- 4-102
Removing the Press Roller Unit --------------------------------------------- 4-105
Preparation -------------------------------------------------------------------------------- 4-105
Procedure ---------------------------------------------------------------------------------- 4-105
Removing the Fold Roller ----------------------------------------------------- 4-108