Canon Booklet Finisher-D1 Service Manual page 147

4
Parts Replacing and Cleaning > Intermediate Process Tray Assembly > Removing the Belt Controller Unit > Procedure
2) Turn the gear [1] in the direction of the arrow until it stops, and push in the Guide
(Front) [2] to the front until it stops.
[2]
3) Slide the Belt Variable Lever [1] in the direction to be engaged.
4) While pushing in the Guide Lever (Rear) [2] to the front, fit the belt-attached [3] pulley
[4] to the hole [A] of the shaft.
5) Fit the cut surface [B] of the shaft with the cut surface [C] of the shaft hole to install
the shaft [5].
[2]
[4]
[3]
[A]
[1]
4 Parts Replacing and Cleaning > Intermediate Process Tray Assembly > Removing the Belt Controller Unit > Procedure
[1]
F-4-199
[C]
[B]
[5]
F-4-200
6) Check that the slope angles [A] of the guide surface of the Guide Lever (Front) [1]
and the guide surface of the Guide Lever (Rear) [2] are the same.
• [A] is at the same angle: Fully tighten the 2 Fixation Screws of the Belt Controller Unit,
and install the removed parts in reverse order.
• [A] is at a different angle: Remove the Belt Controller Unit, and align the slope angles
of the guide surfaces again.
[1]
[2]
4-84
[A]
F-4-201
4-84