Canon Booklet Finisher-D1 Service Manual page 146

4
Parts Replacing and Cleaning > Intermediate Process Tray Assembly > Removing the Belt Controller Unit > Procedure
5) Remove the Belt Controller Unit [1].
• 2 Wire Saddles [2]
• 2 Screws [3]
• 1 Belt [4]
[3]
x2
[1]
[2]
[2]
CAUTION:
When installing the Belt Controller Unit, be sure to align the slope angles [A] of the
guide surface of the Guide Lever (Front) [1] and the guide surface of the Guide Lever
(Rear) [2].The following shows the checking procedure.
[1]
[2]
4 Parts Replacing and Cleaning > Intermediate Process Tray Assembly > Removing the Belt Controller Unit > Procedure
[4]
F-4-196
[A]
F-4-197
1) Hook the belt [2] of the Process Upper Guide Unit on the pulley [1] of the Belt
Controller Unit, and then temporarily tighten the 2 screws [3].
At this time, the position should be such that the belt [4] can be correctly hooked on
the pulley [5].
[4]
[5]
x2
4-83
[2]
[1]
[3]
F-4-198
4-83