Canon Booklet Finisher-D1 Service Manual page 137

4
Parts Replacing and Cleaning > Intermediate Process Tray Assembly > Removing the Front Alignment Motor > Procedure
CAUTION: When placing the Process Upper Tray [1] on a paper stack [2], be sure to
note the following points.
• Place the Process Upper Tray [1] and a paper stack [2] horizontal to the floor.
• Be sure to keep the clearance [A] between the 2 Process Bins [3] and surface of the
floor when placing it.
[3]
[2]
[1]
4 Parts Replacing and Cleaning > Intermediate Process Tray Assembly > Removing the Front Alignment Motor > Procedure
[3]
[A]
[2]
F-4-175
1) Remove the belt [1].
• 1 Screw [2] (to loosen)
• 1 Pulley [3]
2) Remove the belt [4].
• 1 Screw [5] (to loosen)
• 1 Pulley [6]
3) Put a stack of paper [7] to place the Process Upper Tray [8].
[8]
[7]
4) Remove the motor [1].
• 1 Wire Saddle [2]
• 1 Connector [3]
• 2 Screws [4]
[1]
[3]
[2]
x2
[4] [6]
[5]
[2]
[3]
[1]
F-4-176
[4]
F-4-177
4-74
4-74