Removing The Saddle Unit; Preparation; Procedure - Canon Booklet Finisher-D1 Service Manual

4
Parts Replacing and Cleaning > Saddle Stitcher Assembly > Removing the Saddle Unit > Procedure

Removing the Saddle Unit

■ Preparation

1) Open the Front Cover.
2) Pull out the Saddle Unit. (service position)(Refer to page 4-99)

■ Procedure

1) Store the Saddle Unit to the position where the screw [1] can be seen from the hole [2], and
remove the screw [1] and the screw [3].
[2] [1]
[1]
2) Store the rail [1].
4 Parts Replacing and Cleaning > Saddle Stitcher Assembly > Removing the Saddle Unit > Procedure
[3]
F-4-245
[1]
F-4-246
3) Remove the 3 screws [1].
[1]
4) Hold the Saddle Unit [1] as shown in the figure, remove it in the direction of the arrow, and
then carry it after checking that it is removed from the rail.
[1]
4-101
[1]
F-4-247
F-4-248
4-101